Designation: D − 10Standard Test Method for Energy Measurement for This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Purchase your copy of ASTM D – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. ASTM D ,. “Standard. Test Method for Stress Wave. Energy Measurement for Dynamic. Penetrometer. Testing. Systems”. , speclfles.
|Country:||Trinidad & Tobago|
|Published (Last):||12 November 2018|
|PDF File Size:||16.9 Mb|
|ePub File Size:||18.2 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. This procedure may also be applicable to other dynamic penetrometer tests. Contact us svenska Login. Sustainable Development Goals and standardisation, how do they connect? Since the measured energy includes the extra potential energy effect due to the set per blow, tests for energy evaluation of the hammer systems should be limited to moderate N-value ranges between 10 and 50 Ref 7.
Read more about SIS Subscriptions. The inch-pound units given in parentheses are mathematical conversions which are provided for information purposes only and are not considered standard.
ASTM D – 16 – Standard Test Method for Energy Measurement for Dynamic Penetrometers
Awtm of test results in units other than SI shall not be regarded as nonconformance with this test method. Practice D provides a means of evaluating some of those factors. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design. The standard is now in your shopping cart. This procedure may also be applicable to other dynamic penetrometer tests.
What is a standard? It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. In addition, they are representative of the significant digits that generally should be retained. It is not intended for use with down-hole hammers. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations.
In this system, the pound lbf represents a d463 of force weightwhile the unit for mass is slugs.
Standard Test Method for Energy Measurement for Dynamic Penetrometers
Reporting of test results in units other than SI shall not be regarded as nonconformance with this d46333 method. Subscribe on standards – Read more.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM D – 16 Standard Test Method for Energy Measurement for Dynamic Penetrometers
The Standard Penetration Test is the most common type. It is not intended for use with down-hole hammers. The N-value depends on the soil properties but also on the mass, geometry, stroke, anvil, and operating efficiency of the hammer. This energy measurement procedure can evaluate variations of N-value resulting from differences in the hammer system. Your shopping cart is empty. Alternatively, the N-value can be used directly in foundation design using correlations to design parameters such as allowable bearing pressure or pile capacity.
In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of atm standard. Link to Active This link will always route to the current Active version of the standard. Users of this standard are cautioned that compliance asfm Practice D does not in itself assure reliable results. Reliable results depend on many factors: