DC voltage levels in parallel to AC voltage in the ASTM inclined plane tracking and Index Terms — DC Inclined plane test, tracking and erosion, ASTM D ASTM D Standard Test Methods for Liquid-Contaminant, Inclined-Plane Tracking and Erosion of Insulating Materials. The use of polymers covered cables for medium voltage electricity distribution grids is an attractive option in Brazil thanks to their low cost and simplic.
|Published (Last):||1 February 2011|
|PDF File Size:||3.58 Mb|
|ePub File Size:||9.14 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. To arrange tracking tests, request a quote online now or call The recommended minimum number of samples is 20 samples; the preferred number of samples for each material is Such contamination is considered zstm of some severe industrial environments.
The effects are similar to those that may occur in service under the influence of dirt combined with moisture condensed from the d233. A minimum of 5 specimens per material per thickness must be tested, however, that number is only sufficient if the number of drops falls exactly in line with expectations.
Charles, MO Email Us.
ASTM D2303 – Inclined-Plane Tracking and Erosion Tester
Link to Active This link will always route to the current Active version of the standard. Flat surface approximately 2 by 5 inches 50mm by mm and of a thickness rigid enough to support itself without flexing or bending. At least 5 specimens per material per thickness to be tested must be provided; the preferred number is 7 specimens. The condition of the surface of the material will greatly effect r2303 results.
This method evaluates surface tracking and erosion through the material. A minimum of 5 specimens are recommended. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. In this case, the time-to-track technique is used, since time is required to decompose the contaminant solution and build up conducting residues on the sample surface.
Ast is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Watch our video about Inclined Plane Testing. For example, an ionic contaminant containing, in addition, a carbonaceous component such as sugar is substituted to cause tracking on very resistant materials like polymethylmethacrylate. The surface to be tested must be specified. Charles, MO,http: For d23003 studies, only tests as a function of time at constant voltage are useful. Emails are serviced by Constant Contact. One test means up to 5 tests on a single material; the five tests adtm be conducted on different individual test specimens or on a single test specimen if wstm separation between the test locations is sufficient to avoid damage of one test to the surface of another test location.
Approximately x mm and minimum of 1. Dust—and—Fog Tracking and Erosion Resistance of Electrical Insulating Materials This test method evaluates the tracking resistance of a material in a continually wet and dusty environment.
ASTM Testing Procedures And Test List: Eltek International Laboratories
The use of this method for measuring d2033 is consequently important. By submitting this form, you are consenting to receive marketing emails from: All test specimens should be free of surface imperfections such as scratches and bubbles. This is the most harsh of the most common track resistance tests.
The preferred test specimen s: You can unsubscribe anytime. Specific precautionary statements are given in Section 8.
This method recognizes the importance of such variability and suggests the use of special test solutions to meet specific service needs. Subscribe to our YouTube Channel. Use caution when making either direct or comparative service behavior inferences derived from the results of tracking tests.
The preferred test specimens are mm 4 inches diameter disks with a minimum thickness of 2.